| Model: VLMEN |
W : 120 – 300 mm
R : 20 mm
Max. Load: 90° 400 t/m
Operating angle: from 60° – 180°
Die length: 600 mm |
 |
| |
 |
|
| VLMEN Assembly. |
 |
|
|
Part list VLMEN Number of parts is depending of the required length:
| 1 |
VLMEN 1R-1L |
| 2 |
VLMEN 2 |
| 3 |
VLMEN 3 |
| 4 |
VLMEN 4 |
| 5 |
VLMEN SA |
| 6 |
VLMEN nut |
| 7 |
VLME |
| 8 |
VLMEN SS |
| 9 |
VLMEN Bottom holder |
| 10 |
VLMEN Spacer bar |
|
|
| VLMEN Additional tool |
|
|
|
 |
|
|
 |
| VLMEN Insert Die Holder |
|
|
|
| |
|
|
|
| |
|
|
|
 |
|
|
 |
| |
|
|
|
| VLMEN in use |
|
|
|
 |
| |
|
|
|
|
| VLMEN Sample of adjusting. |
|
|
|
 |
|
|
| |
|
 |
First, the securing screws (8) must be loosened until the desired spacer bar width. |
| |
|
 |
Then, the front die halves are pushed backward so that the spacer bars are freely accessible. |
| |
|
 |
The spacer bars (10) can then be removed and replaced by the desired spacer bars. |
|
| Figur 1 |
|
|
|
| |
 |
|
|
| |
|
|
The rear die halves are then pushed against the securing screws so there is space for the desired spacer bars. |
| |
|
|
Now the new spacer bar can be pushed in.. |
|
| Figuur 2 |
|
|
|
| |
 |
|
|
| |
|
|
The rear die halves have to be pushed against the rear spacer bars and there |
| |
|
|
after the securing screws have to tighten softly by hand. |
|
|
|
|
Note:
|
|
When changing from a lager spacer bar opening to a smaller one, the die halves must always be pushed on the spacer bar at each pushed-in length, so that they cannot become detached from each other
|
 |
| |
